|
|
10.5: Repair Time Machine after logic board changes
Not so. It will recognise the earlier snapshots. Why would it not if the only association between the computer and TM is the MAC address. It simply does not make sense for it to be otherwise.
10.5: Repair Time Machine after logic board changes
Yes, I've had the same problem quite a few times. Went through 3 replacement machines of identical configuration, each time Time Machine would initially report 'Backup Failed', saying it couldn't find the backup volume.
10.5: Repair Time Machine after logic board changes
Yep - I ran a few tests on this scenario and you're correct. I was not able to figure out just how to fake TM into continuing on from where it was. It does always make a new FULL backup. :( Bummer. |
SearchFrom our Sponsor...Latest Mountain Lion HintsWhat's New:HintsNo new hintsComments last 2 daysLinks last 2 weeksNo recent new linksWhat's New in the Forums?
Hints by TopicNews from Macworld
From Our Sponsors |
|
Copyright © 2014 IDG Consumer & SMB (Privacy Policy) Contact Us All trademarks and copyrights on this page are owned by their respective owners. |
Visit other IDG sites: |
|
|
|
Created this page in 0.33 seconds |
|