|
|
Reduce pressure on laptop power cord connectors
Doing that will put more stress on the cable where it's attached to the clip (it will be bending at a very sharp angle), rather than putting the stress where it should be, on the stress reliever built into the end of the plug (which causes it to bend at a larger radius). I'd guess this will cause the the wire to break even faster.
Reduce pressure on laptop power cord connectors
I disagree, any such stress would simply force the cable to 'pop' out of the clip.
Reduce pressure on laptop power cord connectors
I'm talking about the location where the cable is not attached to the clip, and it will now be bent at a sharp angle around a sharp[er] object than the stain relief on the plug. Repeated bending there from everyday movement of the cable/computer will cause it to fail faster. |
SearchFrom our Sponsor...Latest Mountain Lion HintsWhat's New:HintsNo new hintsComments last 2 daysLinks last 2 weeksNo recent new linksWhat's New in the Forums?
Hints by TopicNews from Macworld
From Our Sponsors |
|
Copyright © 2014 IDG Consumer & SMB (Privacy Policy) Contact Us All trademarks and copyrights on this page are owned by their respective owners. |
Visit other IDG sites: |
|
|
|
Created this page in 0.20 seconds |
|