Submit Hint Search The Forums LinksStatsPollsHeadlinesRSS
14,000 hints and counting!


Problems | 12 comments | Create New Account
Click here to return to the 'Problems' hint
The following comments are owned by whoever posted them. This site is not responsible for what they say.
Problems
Authored by: sjonke on Jun 22, '05 09:32:04AM

I installed it, created a rule which I set to key 1 that just marks a message flagged. I have it set to apply to all rules, which I presume I have to set. I open a message, hit the ` key and the bezel comes up and lists my key 1 rule, I press 1, it says the message is flagged, but it hasn't been flagged. I did one time, and so far only one time, have it actually flag a message, but that is it. Anyone else seeing this? Running 10.4.1.

---
--- What?



[ Reply to This | # ]
Problems
Authored by: deleted_user12 on Jun 22, '05 05:20:19PM

I checked, it works in my case, but I was able to duplicate your problem.

Problem could be: your mail is also on a network server -> try to refresh it (go to another folder and then return). Or try on a local folder from On my Mac - it should work there.

Messages I had stored on my local folders appeared instantly with the flag. Others (from the .Mac account e.g.) didn't until I refreshed the pane.

If not, then there's another problem involved.



[ Reply to This | # ]
Problems
Authored by: sjonke on Jun 23, '05 04:43:39PM

You are correct sir. That seems to be the problem. When you try to use it on a .Mac message, the flag doesn't show up until you switch to another mailbox and back again. Presumably this would be the case on any IMAP server mail, but I can't test that. I've reported this issue to the author.

---
--- What?



[ Reply to This | # ]