Submit Hint Search The Forums LinksStatsPollsHeadlinesRSS
14,000 hints and counting!


Click here to return to the 'Set up Airport Express and third-party wireless' hint
The following comments are owned by whoever posted them. This site is not responsible for what they say.
Set up Airport Express and third-party wireless
Authored by: hpeyerl on Mar 11, '05 01:03:20PM

So, I'm confused. I successfully used my AE to extend a wireless network (so I could work in the pub across the foyer last time I was working overseas), and I normally use it as my remote speakers at work... Now I want to take it home and use it as remote speakers on my G4 tower which doesn't have wireless...

So I think what I want to do is pair the AE to my WRT54G at home, and then hope that iTunes will see the wireless-AE through my wired ethernet connection to the WRT54G... Am I smoking something or will this 'just work'? I was about to buy an 802.11 adapter for my G4 tower but if this will 'just work' then I'll forgo that.



[ Reply to This | # ]
Set up Airport Express and third-party wireless
Authored by: momoe on Mar 12, '05 01:31:19PM

This may help...

I just tried to open Airport Express Assistant on my Airport-less G3 iMac (directly connected to the Linksys WRT54G) and it states "This computer does not have a wireless card installed" and quits.

Opening Airport Admin Utility however, shows my Airport Express "Living Room" and the AE can be configured from this computer.

But the caveat is that this AE was already configured by a Airport-enabled computer and is currently running.

Since you have already set up the unit at work, it may be ready to go if you plug it in at home.

Let us know.

momoe

---
Mac User & Enthusiast for over 20 Years!



[ Reply to This | # ]
Set up Airport Express and third-party wireless
Authored by: hpeyerl on Mar 14, '05 09:43:45AM

Yes, it did 'just work' amazingly. Since I wasn't told the password to the AE when I was overseas and it was previously setup to extend the office network, I had to do a hard-reset and reconfigure it from scratch. I simply plugged it into my ethernet, ran the setup utility, configured it to act as remote speakers, and to join my existing wireless network. I then unplugged it, moved it over to the stereo, plugged it in, and voila! It just worked.



[ Reply to This | # ]