Submit Hint Search The Forums LinksStatsPollsHeadlinesRSS
14,000 hints and counting!


Click here to return to the 'Console connect to Cisco routers via minicom' hint
The following comments are owned by whoever posted them. This site is not responsible for what they say.
Console connect to Cisco routers via minicom
Authored by: mautro on May 29, '04 05:04:37AM

It's ok,but if I would admin a sun sparc via minicom/zterm the only things I should change are the Bps/Par/Bits parameters (and the cable,of course)?
Regards
Mauro



[ Reply to This | # ]
Console connect to Cisco routers via minicom
Authored by: macubergeek on May 29, '04 06:29:23PM

I have not consoled onto a sun box in a while but I think 8none1 & no flow control should be fine assuming you have proper null modem cable.



[ Reply to This | # ]
Console connect to Cisco routers via minicom
Authored by: macubergeek on May 29, '04 06:33:26PM

I take that back
My pc is consoled into my sparc box and it uses 9600 8none1 and no flow control and it works fine (with Hyperterminal)
So go ahead and use the same settings in Zterm.



[ Reply to This | # ]