|
|
Installing OS 10.2 on Beige G3
There's no way around this problem, except with either a
Installing OS 10.2 on Beige G3
I'm afraid you're wrong. I'm currently running os-x 10.2.6 on
Installing OS 10.2 on Beige G3
I just got a G3 AIO 266. I would like to put the hard drive that was in my iMac (I just put a 20 gig drive in it) in the AIO. It is a 10 GB Maxtor 5400RPM ATA 66 drive. I got a Promise Technology ATA 66 card for it. What will I need to do to boot from that card. Also if at all possible I would like to boot from the existing system on the drive so that I don't have to reload everything. Is this doable? I am supposed to get the AIO via UPS tomorrow.
Installing OS 10.2 on Beige G3
OK so I partitioned and installedon a 100gig HD but now my OS X partition is filling up and I have 80+ gig on the other partition. G3 266/400+ ram. I am handy with a soldering iron but would rather upgrade the SCSI controller. Any suggestions? |
SearchFrom our Sponsor...Latest Mountain Lion HintsWhat's New:Hints1 new Hints in the last 24 hoursComments last 2 daysNo new commentsLinks last 2 weeksNo recent new linksWhat's New in the Forums?
Hints by TopicNews from Macworld
From Our Sponsors |
|
Copyright © 2014 IDG Consumer & SMB (Privacy Policy) Contact Us All trademarks and copyrights on this page are owned by their respective owners. |
Visit other IDG sites: |
|
|
|
Created this page in 0.28 seconds |
|