Submit Hint Search The Forums LinksStatsPollsHeadlinesRSS
14,000 hints and counting!


Click here to return to the 'have to remove password first' hint
The following comments are owned by whoever posted them. This site is not responsible for what they say.
have to remove password first
Authored by: qoo77 on Dec 27, '02 09:17:47AM
For those getting the "Error code 2: Invalid Password" message, try this: 1) Go to http://192.168.1.1/Passwd.htm and change your router's password to blank. 2) Trying 'putting' code.bin again 3) It pauses for a while then something like this will show "Sent 386048 bytes in 18.3 seconds " 4) Return to http://192.168.1.1/Passwd.htm and you can restore your router's password to your own. 5) Done! You can click on the 'Password' link to check that the firmware version is at the latest.

[ Reply to This | # ]
have to remove password first
Authored by: macubergeek on Dec 27, '02 03:02:39PM

word of advice
blank the password by clicking inside the first window at the end of the line of dots then blanking by using the delete button on your keyboard till all the dots are gone.
do the same in the second password box

be sure to hit apply at the bottom of the page

then do the tftp thing:
jamesk @ /Users/jamesk/Desktop/update@Xmac-->tftp 192.168.1.1
tftp> binary
tftp> put code.bin
Sent 453632 bytes in 24.2 seconds

One last caveat:
if you are using firewalling on your mac, be sure to flush the ruleset before you try this and then reinstall using brickhouse.
you can flush the rules by:
sudo ipfw flush
enter password



[ Reply to This | # ]