|
|
Re: 10.7: Re-enable syslogd for incoming connections
Close. If you put the full path it works. Without the full path, it looks in the user's own preferences folder. So, the command would be:
And of course you still have to unload/load
Re: 10.7: Re-enable syslogd for incoming connections
The above comments should be removed. I tried taking this shortcut but it completely destroyed the file. Luckily I had a back-up. Even if it did add the new entries it wouldn't have worked. It must go under 'Sockets'. Same mistake as the posted hint. Thanks @Frankus for the correction in the post below.
Re: 10.7: Re-enable syslogd for incoming connections
The comment was only meant to illustrate how one could use the defaults command to modify a launchd.plist. Unfortunately, there is little I can do about the original hint's accuracy. I lack the power to edit or delete it regardless.
Re: 10.7: Re-enable syslogd for incoming connections
It wiped the file clean but the weird thing is that I just tested the `defaults` command again on a copy of the file and it worked. It even fell within the 'Sockets' dict group so I have no idea. Something else must have been at play. |
SearchFrom our Sponsor...Latest Mountain Lion HintsWhat's New:HintsNo new hintsComments last 2 daysLinks last 2 weeksNo recent new linksWhat's New in the Forums?
Hints by TopicNews from Macworld
From Our Sponsors |
|
Copyright © 2014 IDG Consumer & SMB (Privacy Policy) Contact Us All trademarks and copyrights on this page are owned by their respective owners. |
Visit other IDG sites: |
|
|
|
Created this page in 0.09 seconds |
|