Submit Hint Search The Forums LinksStatsPollsHeadlinesRSS
14,000 hints and counting!


Click here to return to the 'Installation guide for Tomato firmware on a Buffalo router' hint
The following comments are owned by whoever posted them. This site is not responsible for what they say.
Installation guide for Tomato firmware on a Buffalo router
Authored by: houlia on Oct 19, '09 03:14:20PM

I just used this, a couple notes: by "use the LAN port" I believe he means the port marked "1" on the router - I was using 4 without any luck. Also, with the Buffalo routers, make sure you hold the init button (the one you need a pen to press) down until the red light flashes on, otherwise the router goes into some sort of different boot mode. You can tell you're doing it right if the pings work for a quick period of about 5 seconds, then stop working again.



[ Reply to This | # ]