|
|
10.5: Virtualize machine-specific 10.4 in Fusion 2
On my experimental Tiger VM (the one described in the hint), NAT networking works flawlessly, while bridged mode doesn't connect (at least the first time I booted): it looks similar to a problem I had in Ubuntu with bridged networking, where I had to edit /etc/sysctl.conf, adding these lines:
10.5: Virtualize machine-specific 10.4 in Fusion 2
Both NAT and Bridged appear to work fine after a reboot of the host. Pshaw! I rebooted after reinstalling VMWare so I didn't think to do it again.
10.5: Virtualize machine-specific 10.4 in Fusion 2
Same here: both NAT and bridged mode now work in my experimental Tiger VM, too - at least, this problem is solved! ;-) :-) |
SearchFrom our Sponsor...Latest Mountain Lion HintsWhat's New:HintsNo new hintsComments last 2 daysLinks last 2 weeksNo recent new linksWhat's New in the Forums?
Hints by TopicNews from Macworld
From Our Sponsors |
|
Copyright © 2014 IDG Consumer & SMB (Privacy Policy) Contact Us All trademarks and copyrights on this page are owned by their respective owners. |
Visit other IDG sites: |
|
|
|
Created this page in 0.17 seconds |
|