- Install Palm Desktop (4.0.2).
- Install Belkin OS X 10.2 Beta drivers.
- Install iSync.
- Install iSync palm conduit.
- In HotSyncManager, make sure nothing is checked under connect settings except "USB serial-port."
|
|
|
Without too much problem, I managed to sync the
non-approved Palm III with iSync 1.2.1 using the Belkin USB2Serial adapter F5U109:
•
[4,917 views]
Hint Options
Use a Palm III with Isync via Belkin USB2Serial
Sorry, but where do you get the Belkin OS X Beta drivers? I've put off buying the serial to PDA adapter because there are no drivers available
Use a Palm III with Isync via Belkin USB2Serial
Yup, this link is key to the this hint http://www.belkin.com/beta/
Use a Palm III with Isync via Belkin USB2Serial
I too have been sitting on this equipment, however, even with the 10.2 Beta driver I can't get it to work with my PIIIx. (OSX 10.2.8 on a Graphite 500MHz G3 iMac with 640 Mb RAM)
Use a Palm III with Isync via Belkin USB2Serial
Did you ever get this to work? I too have downloaded the beta driver but can't get it to work on my new powerbook G4
Use a Palm III with Isync via Belkin USB2Serial
The link to the beta drivers for the Belkin adaptor, www.belkin.com/drivers, no longer exists.
Use a Palm III with Isync via Belkin USB2Serial
Why not just use the Keyspan usb to serial. I've been using this for almost a year now?
Use a Palm III with Isync via Belkin USB2Serial
Stubborness! |
SearchFrom our Sponsor...Latest Mountain Lion HintsWhat's New:HintsNo new hintsComments last 2 daysLinks last 2 weeksNo recent new linksWhat's New in the Forums?
Hints by TopicNews from Macworld
From Our Sponsors |
|
Copyright © 2014 IDG Consumer & SMB (Privacy Policy) Contact Us All trademarks and copyrights on this page are owned by their respective owners. |
Visit other IDG sites: |
|
|
|
Created this page in 0.34 seconds |
|